After extended use, the saw’s dust collection system may become clogged. If the saw is used on a table or other surface without an opening on the bottom, clean out the base and accumulated saw dust after each cut. However, some dust will fall inside the base. If the saw is operated without a vacuum attached, most of the dust will be blown out the dust collection port. For best results, connect a vacuum to the port at the rear of the saw. Your table saw is equipped with a dust shroud and dust collection port. Be sure to place the guard and standard throat plate back in position and check adjustments when the dado cuts are complete. DO NOT USE WIDER COMBINATIONS.ĬAUTION: Always check dado blade clearance before Maximum dado width on this saw is 13/16" (20mm). use several successive passes rather than attempting to make it with one pass. Use EXTREME care when using the dado without the guard. When using the dado, the guard must be removed. A dado cut is commonly used to add support and line up a shelf for a cabinet, bookcase or some such project. Anytime a cut is required that is considerably wider than the saw kerf, a dado is used. When using the dado, the special dado insert (also sold as an accessory) must be used. After stowing the saw, pick the stand up by both rails and close it by squeezing the top rails toward each other. Pull the saw forward and up allowing the front bar to slide out of the lip on the stand.
Tilt the rear of the saw up allowing the rear feet to clear the lip on the back of the stand. Remove the bolts from the rear rail of the saw. Be sure the saw does not rock or wobble in place. Secure the rear of the saw with the bolts provided (Fig. Lower the rear feet of the saw onto the ledge (B) at the back of the stand as shown in Figure 3. Place the front bar of the saw into the lip (A) on the front of the stand (Fig. Unfold the saw stand until it is fully opened. (68.1 kg.) SAVE THESE INSTRUCTIONS ASSEMBLY Use the saw stand and operate the table saw from the front side only.
Do not use saw stand if it is damaged or bent.Do not use saw stand on inclined, uneven or unstable surfaces.Position all of the feet in the same orientation or unstable footing may occur.DO NOT mount the table saw to the stand in any other orientation.Do not use this stand with any other tool. This table saw stand is designed only for use with the DW745 table saw.When servicing this tool, use only identical replacement parts. Failure to heed these warn- ings may result in personal injury and serious damage to the table saw and the accessory. W ARNING: F or your o wn safety, read the table sa w instr uction manual before using any accessory.
0 kommentar(er)
